Integration instructions for host product manufacturers according to KDB 996369 D03 OEM
Manual v01
2.2 List of applicable FCC rules
CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular transmitter
2.3 Specific operational use conditions
Thismoduleisstand-alonemodular.IftheendproductwillinvolvetheMultiplesimultaneouslytransmittingcondition
ordifferentoperationalconditionsforastand-alonemodulartransmitterinahost,hostmanufacturerhavetoconsult
withmodulemanufacturerfortheinstallationmethodinendsystem.
2.4 Limited module procedures
Not applicable
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
2.7 Antennas
This radio transmitter E220-400T30S has been approved by Federal Communications Commission to operate with the antenna
types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater
than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
Antenna No.
Operate frequency band
Antenna Type
Maximum antenna gain
Antenna 1
433.125MHz
External Antenna
0dBi
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains FCC ID:
2ALPH
‐
E220
".
2.9 Information on test modes and additional testing requirements
Host manufacturer is strongly recommended to confirm compliance with FCC requirements for the transmitter when the module
is installed in the host.
2.10 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with all other applicable requirements
for the system such as Part 15 B.
Summary of Contents for E220-400T30S
Page 1: ...E220 400T30S User Manual ...
