Chengdu Ebyte Electronic Technology Co.,Ltd.
Copyright ©2012–2020
Chengdu Ebyte Electronic Technology Co.,Ltd.
27
note
When entering
other modes from the setup mode, the
module will reconfigure the parameters, and AUX will
remain low during the configuration process;
The output level is high after completion, so it is recommended that the user detect the rising edge of the AUX.
6.6 Wake mode (mode 4).
state
M2
、
M1
、
M0 = 100
launch
Wireless data transmission is possible.
reception
Wireless data reception is not possible.
Baud rate and
airspeed
In this mode, the serial port baud rate and airspeed are independent, and the sending and receiving parties can have
different serial port baud rates, but must have the same airspeed setting.
merit
Can wake up receivers operating in mode 6; The wake code is automatically increased before launch, and the number
of increases depends on the wake-up time setting.
shortcoming
The transmission time is long, and it is only suitable for waking the receiver, not for conventional transmission data.
Applicable scenarios
Used to wake up receivers in WOR state.
note
In wake-up mode, the maximum transmit length
of a
single packet
is
84 bytes (excluding directed addresses and
channels).
6.7 Configuration Mode (Mode 5).
state
M2
、
M1
、
M0=101
launch
Wireless transmission is not possible, and the data of the serial port is regarded as a configuration instruction.
reception
Wireless reception is not possible.
disposition
It can be used for module parameter setting,
using serial ports
9600
,
8N1, to set module working parameters
through a specific instruction format
note
When entering
other modes from the setup mode, the
module will reconfigure the parameters, and AUX will
remain low during the configuration process;
The output level is high after completion, so it is recommended that the user detect the rising edge of the AUX.
6.8 Power saving mode (mode 6).
state
M2
、
M1
、
M0 = 110
launch
No wireless data transmission.
reception
Wireless data reception is possible.
Baud rate and
airspeed
In this mode, the serial port baud rate and airspeed are independent, and the sending and receiving parties can have
different serial port baud rates, but must have the same airspeed setting.
merit
The module works in the WOR state, periodically automatically wakes up and listens to the air wireless packets, when
