Chengdu Ebyte Electronic Technology Co.,Ltd.
Copyright ©2012–2020
Chengdu Ebyte Electronic Technology Co.,Ltd.
34
voltage, the smaller the power;
The use of antennas is poorly matched with the module or the quality of the antenna itself is a problem.
11.2 Modules are prone to breakage
Please check the power supply to ensure that between the recommended supply voltages, if the maximum value is
exceeded, the module will be permanently damaged;
Please check the stability of the power supply, the voltage can not fluctuate sharply and frequently;
Please ensure that
the
installation and use process anti-static operation, high-frequency device electrostatic sensitivity;
Please ensure that the humidity during installation and use should not be too high, and some components are
humidity-sensitive devices;
If there is no special need, it is not recommended to use it at too high or too low temperature.
11.3 The bit error rate is too high
There is co-frequency signal interference nearby, stay away from the source of interference or modify the frequency and
channel to avoid interference;
The power supply is not ideal, it may also cause garbled codes, and the reliability of the power supply must be
guaranteed;
Poor quality or long extension cables and feeders will also cause high bit error rates.
Chapter 12 Welding Operation Instructions
12.1 Reflow soldering temperature
Reflow curve features
There is lead process
assembly
Lead-free process assembly
Preheating/insulation
Minimum temperature
(
Tsmin
).
100℃
150℃
Maximum temperature
(T
smax
).
150℃
200℃
Time (T
smin
~T
smin
).
60-120 seconds
60-120 seconds
