Chengdu Ebyte Electronic Technology Co.,Ltd.
【2DI + 2AI + 4DO】MA02-AACX2240 User Manual
Copyright ©2012–2021
，
Chengdu Ebyte Electronic Technology Co.,Ltd.
17
4.3.2 Switch output DO mode setting
(1) Level mode
Output according to the level set by the user. The switching characteristics of the level mode are similar to the
function of a self-locking switch.
(2) Pulse mode
After the switch output DO is turned on, the set pulse width time (in ms) is maintained, and the switch output DO is
automatically turned off. The pulse width setting range is 50
～
65535 (default 50).
(3) Follow mode
After the user sets the follow mode, set the follow input terminal. The switch output DO terminal is consistent with
the DI input terminal.
Note: Multiple switch output DO terminals can be set to follow one DI input terminal, and one switch output DO
terminal can not be set to follow multiple DI input terminals.
4.4 Device address
4.4.1 Device address
Device address composition: hardware a software offset address
Figure 4-4-1 Device address
The default device address is 32 (hardware address 31 + software address 1 = device address 32).
Device address setting range: 1
～
247.
Hardware address: realized by the dial switch (5 digits) dial setting (the factory default is 31).
Software address: It is realized by the "offset address" set by the configuration tool software (the factory default is 1).
For example:
If the hardware address is set to 5 and the software address is set to 113, the device address is 118.
