ECA PROTEUS PREMIX PPR Series, Operating Manual

*All installations in England and Wales must be

to Local Authority Building Control (LABC

)

either directly or through a

Competent Persons Scheme. A Building Regulations Compliance

will then be issued to the customer.

www.centralheating.co.uk

© 

H

eating and 

H

otwater Industry Council (

HH

IC

)

Th

i

s

Comm

i

ss

i

on

i

ng

Check

li

st

 i

s

to

be

comp

l

eted

 i

n

 f

u

ll 

by

the

competent

person

who

comm

i

ss

i

oned

the

bo

il

er

as

a

means

o

f 

demonstrat

i

ng

comp

li

ance

w

i

th

the

appropr

i

ate

Bu

il

d

i

ng

Regu

l

at

i

ons

and

then

handed

to

the

customer

to

keep

 f

or

 f

uture

re

f

erence.

Failure to install and commission according to the manufacturer’s instructions and complete this Benchmark Commissioning Checklist will invalidate the 
warranty. This does not affect the customer’s statutory rights.

GAS

BO

I

LER

SYSTEM

COMM

I

SS

I

ON

I

NG

CHECKL

I

ST

Customer name:

Telephone number:

Address:

Boiler make and model:

Boiler serial number:

Commissioned by (PRINT NAME

)

:

Gas Safe register number:

Company name:

Telephone number:

Company address:

Commissioning date:

CONTROLS

 (tick the appropriate boxes

)

Time and temperature control to heating

Room thermostat and programmer/timer

Programmable room thermostat

Load/weather compensation

Optimum start control

Time and temperature control to hot water

Cylinder thermostat and programmer/timer

Combination Boiler

H

eating zone valves

Fitted

Not required

H

ot water zone valves

Fitted

Not required

Thermostatic radiator valves

Fitted

Not required

Automatic bypass to system

Fitted

Not required

Boiler interlock

Provided

ALL

SYSTEMS

’s instructions

Yes

What system cleaner was used?

What inhibitor was used?

Quantity

litres

Yes

No

CENTRAL

HEAT

I

NG

MODE

measure and record:

Gas rate

m³/hr

OR

ft³/hr

Burner operating pressure (if applicable

)

mbar

OR

 Gas inlet pressure

mbar

°C

Central heating return temperature

°C

COMB

I

NAT

I

ON

BO

I

LERS

ONLY

Is the installation in a hard water area (above 200ppm

)

?

Yes

No

Yes

No

DOMEST

I

C

HOT

WATER

MODE

 Measure and Record:

Gas rate

m³/hr

OR

ft³/hr

Burner operating pressure (at maximum rate

)

mbar

OR

 Gas inlet pressure at maximum rate

mbar

Cold water inlet temperature

°C

H

ot water has been checked at all outlets

Yes

Temperature

°C

I/min

CONDENS

I

NG

BO

I

LERS

ONLY

The condensate drain has been installed in accordance with the manufacturer’s instructions and/or BS5546/BS6798

Yes

ALL

 I

NSTALLAT

I

ONS

Record the following:

At max. rate:

CO       

ppm

AND

CO/CO²

Ratio

At min. rate: (where possible

)

       CO

ppm

AND

CO/CO²

Ratio

The heating and hot water system complies with the appropriate Building Regulations

Yes

The boiler and associated products have been installed and commissioned in accordance with the manufacturer’s instructions

Yes

The operation of the boiler and system controls have been demonstrated to and understood by the customer

Yes

The manufacturer’s literature, including Benchmark Checklist and Service Record, has been explained and left with the customer

Yes

Commissioning Engineer’s Signature

Customer’s Signature

www.centralheating.co.uk

45