5 EyesMap Modules
User Manual
44
It is not necessary to select all points in the same photograph, although it is
recommendable. You can move through the different photographs by simply selecting
them in the image gallery at the bottom of the screen.
If you have used the stereoTarget for scaling, check that it has been correctly detected
in the corresponding images (a cross is displayed in the centre of the detected target).
Remember that you can also do scaling with the
“
Scale
”
tool.
The tools available in this screen are the following:
Coordinate Measurement
Select this if you wish to obtain the three-dimensional coordinate of a
point. To make your selection, you must first double click on the point in
the image and then click on confirm.
Distance Measurement
Select this if you wish to measure the distance between two points. Once
you have activated this option, you must select each one of the two
points as if they were simple coordinates.
Summary of Contents for eyesmap
