32
33
1. When parking tow cars in the same line keep a distance of
1m from one car behind another.
2. Move the trailer to a suitable
position, then remove screw D
first. Hang the trailer cover A om
the ball B, press down ball lock
C, and after that install screw D
back and tighten.
3. Open box E, and connect
battery cables according to the
socket. All cables must be well
connected.
Please don't take all the cable
terminals out from the socket to
make sure all the cables are in
proper order.
When separating towing vehicle
and trailer please open the power
supply box first, then loosen the
harness. Fix the point of the
towing vehicle from the power
supply box and take out the plugs.
4. Tightening the fixing screw for
water-proof cover and protection
chain.
When reconnecting the trailer, leave
a suitable harness, not too short,
that the car will drag on the ground.
Test the length of the harness
needed for turning.
Please remove harness first.
Hand Brake Checking
1. Please check if hand brake is
working properly.
2. The hand brake is located inside
the second row seat. Open the seat.
When leaving the car to park
it for a long time please pull
the hand brake of the towing
vehicle first then the hand
brake of the trailer. Even
when parked separately make
sure hand brakes are pulled
up.
Summary of Contents for Sightseeing Bus
Page 5: ...34 34 Main power switch STOP STRUCTURE AND SPECIFICATION...
Page 8: ...Electrical accelerator 0 5k...
Page 9: ...Electrical accelerator 0 5k...
Page 21: ...36 37...