Page 2 of 3
Bracket Mounting:
1. Select a mounting location for the unit on a flat surface.
2. Secure the light head with the supplied hardware as shown in Figure 1.
Aiming Instructions:
Installer is responsible for ensuring the headlights are aimed properly such that beams comply with current highway regulations. Beams should
project the same distance ahead as compliant OEM headlights.
FIGURE 2
Wiring Instructions:
The wiring configuration is as shown in Figure 2. Use the supplied mating connector All wiring should be a minimum of 18 AWG. The positive line
must have a slow blow 25 amp fuse. Routing the ground wire directly back to negative battery terminal is recommended. Pack dielectric grease,
such as Dow Corning 4, around each electric connection exposed to moisture or the ambient environment.
Important! Disable power before wiring the product.
FIGURE 1
Ground (-) (Black)
High Beams (Red)
Low Beams (Yellow)
Parking Light (Green)
Indicator Light (Grey)
25A In-line
Fuse
Ignition
Switch
Not Used (Blue)
MOUNTING
SURFACE
BOLT
SLIDE BLOCK
ANTI-SLIP SHEET
BASE BLOCK
FLAT GASKET
SELF-LOCKING NUT
