- 16 -
3. Connection of the power cable to the spray gun
After cleaning the metal connector at the end of power cable fixed to gun with clean cloth,
connect it securely to output terminal (OUTPUT) on the control unit.
Attach the cable to the gun by tightening it manually.
After the attachment, use a stopper for locking. Do not tighten excessively when the
attachment position does not seem to be correct. In such cases, attach the cable so that the
surface of the stopper may closely contact to the hexagonal plain part while loosening the nut.
Fix the cable and the air hose with the insulation lock at the position 70 to 80cm from the gun.
At this time, allowance is required for the cable so as not to apply load to the root part of the
connector.
When the cable, air hose, paint hose or the like are held together with a tape, a small allowance
is needed so as not to apply the tensile force to the cable. If a tension is applied to the cable
during operation, this might lead to breakage of the cable. See
“6. CAUTIONS WHEN BANDING
L. V. CABLE WITH HOSES” for more details.
CAUTION
