- 17 -
4. Connection of air hose
Connect one end of the air hose to the nipple at rear side of the spray gun (next to power cable)
and the other end to the air exit on the control unit and tighten (G 1/4 fitting). It is recommended
that the spanner of 17mm be used.
*The case in which two hoses are used.
Be sure to use two spanners when the air hose or paint hose is attached to the gun in order to
prevent applying excessive force to the gun. In addition, do not allow the spanner to contact the
cable connector at the time of attaching or removing.
Effective atomization can be obtained by using an air hose of 3/8 inch when the air hose is longer
than 10m. Attach a joint bushing to have a screw opening of G 3/8.
5. Connection of paint hose
One end of the paint hose should be connected to the nipple at the front side and the lower end of
the gun grip (front side of the cable), and the other end of the paint hose is attached to the pump
system.
CAUTION
CAUTION
