- 38 -
(5) Take out the cascade 7(6004 0330 97) from the barrel. The two O-rings 44(0663 9306 10)
should be replaced.
(6) Care must be taken not to connect the colored wires to their responding terminals on the
cascade.
The precision Philips screwdriver is required for this operation.
(7) To assemble the cascade, put it into body 1 (6004 0330 60) turning it a few times to make
sure the lead wires are correct, then attach the barrel. Make sure that the cushion 35 (6004
0330 90) is set in its correct position. Confirm that the shoulder part of cascade is in place
against the face of the gun body. Each time the barrel is removed, the gasket 28 (6004 0330
84) should be replaced.
Green(GND
)
Yellow (SOURCE)
Red (RNT)
