die lust am hören
Marketing - Dienstleistung - Schnellhörtester - Hörgeräte-Servicetools
e
ccola
page 5 of 9
Update April 2022
Slowly move the attachment about 5 to 6 times in both directions and
drain the apertures. In case of heavy debris it might be helpful to clean
the receiver by applying the ecco-cleaner detergent (included in the
shipment and can be reordered). Leave it for some minutes and clean
the receiver again by means of the red vacuum hose.
Switch off the equipment after use by means of the right hand switch
(switch position „0“).
The blue hose is intended to drain the support hooks and sound
transmission tubes. This will work as soon as the switch is set on
„SAUGEN (sucking) and turned on.
7.
Drying of Hearing Aids
Put the hearing aid (max. 2 hearing aids) on the rubber pad and put the
drying cup on top. Suggestion: Prior to that, remove the support hook
and /or all filter systems. The hearing aid should not be placed directly
above the vacuum aperture, in order to ensure the build-up of an
optimum vacuum. Set the switch at the left hand side upwards on
„TROCKNEN“(Drying). The chosen function will be shown by the light
emitting diode (green). In order to make use of the time switch and
vacuum chamber it is recommended to set the right hand switch
upwards on „ZEIT 5 min.“ (TIME 5 min.) and to confirm it by means of
the red start button.
Please pay attention: Please press the drying
cup strongly on the rubber plate, so that the pressure can be build
up.
The barometer should read between –0,7 and – 0,8 bar. The
equipment will be switched on for about 5 minutes and will then
automatically be switched off. The remaining time is shown by the digital
