English
English
6
INTRODUCTION
Thank you for purchasing this television� In order to use this device to its full potential from the very start, read
this manual carefully and keep for future use�
ATTENTION
Do not tamper with any internal components and do not make any adjustments that are not defined in this
manual� LED TVs use high voltage� When cleaning dust or drops off the display or device case, first unplug the
power cord from the socket and then wipe the device with a dry towel� To prevent damaging the TV, disconnect
the power cord and antenna during a thunderstorm� Contact a qualified service centre for all necessary repairs�
TV INSTALLATION AND CONNECTION
Instructions for assembling the stand
1� Open the carton and remove the TV and scattered accessories and
base (some models without base)�
2� To avoid the damage ot the TV, covered with a soft mattres, put it in
the table face down on a soft mattress�
3� Clip base on card slot as the direction of arrow shown�
4� The installation is completed�
Positioning
•
Place the unit within the room so that the display is not exposed to direct sunlight�
•
Complete darkness or reflections on the screen can cause eye fatigue� Soft indirect light is recommended
for comfortable viewing�
•
Leave enough space between the TV and wall to allow sufficient air
circulation�
•
Stay away from excessively warm areas to prevent damaging the TV
frame or the premature ageing of components�
•
Do not cover ventilation holes�
Antenna and power connection
1� Connect the antenna cable to the antenna connector on the back
of the TV�
2� Plug the power cord into the electric socket�
3� Switch the TV on�
Press the On/Off switch on the TV� The indicator will turn green� When
the TV is in standby mode (red indicator), the TV can be turned on by
pressing a button on the remote controller�
Summary of Contents for 24 H04T2S2
Page 2: ......
