52
GB
INTRODUCTION
Thank you for purchasing this television product. In order to use this device to its full potential from the very
start, read this manual carefully and keep handy for future use.
ATTENTION
Do not tamper with any internal device components and do not perform any adjustments that are not defi ned
in this manual. LED TVs use high voltage. When cleaning dust from the screen or the cabinet of the device,
you should fi rst unplug the power cord from the outlet and then wipe the device with dry cloth. To prevent
damaging the TV, disconnect the power cord and antenna during a thunderstorm. Refer to a qualifi ed service
centre for all necessary repairs.
ATTENTION:
Long term static image may permanently damage the TV set.
•
Make sure that the static image does not stay on the screen of the LED TV longer than 2 hours. Otherwise,
it could cause permanent burning of the image onto the screen. When displaying a static image, lower the
brightness and the contrast to prevent permanent damage to the screen.
•
Watching for long time TV in the screen aspect ratio 4:3 may cause permanent bars on the sides of the
screen. When an image from video games or PC is displayed long-term it could cause burning of the static
image onto the screen. When displaying a static image, lower the brightness and the contrast.
TV INSTALLATION AND SETUP
Instructions for assembling the stand
1. Place the device on a fl at service with the screen facing down. Use a blanket or
other soft fabric to protect the display.
2. First, place plastic label on the turning axis.
3. Insert the stand into the holder on the bottom of the TV set.
4. Tighten the stand fi rmly in the holder, using the included screws.
Positioning
•
Place the unit within the room so that the display
is not exposed to direct sunlight.
•
Complete darkness or refl ections on the screen
can cause eye fatigue. Soft indirect light is
recommended for comfortable viewing.
•
Leave enough space between the device and wall
to allow suffi
cient air circulation.
•
Stay away from excessively warm areas to prevent
damaging the case of the device or the premature
ageing of components.
•
Do not cover ventilation holes.
Antenna and power connection
1. Connect the antenna cable to the antenna connector on the back side of the TV.
2. Plug the power cord into the electric socket.
V-stand + glass
Square stand + glass
