GB
52
INTRODUCTION
Thank you for purchasing this television product. In order to use this device to its full potential from the very
start, read this manual carefully and keep handy for future use.
ATTENTION
Do not tamper with any internal device components and do not perform any adjustments that are not defi ned
in this manual. LED TVs use high voltage. When cleaning dust or drops off the display or device case, you
should fi rst unplug the power cord from the socket and then wipe the device with a dry towel. To prevent
damaging the TV, disconnect the power cord and antenna during a thunderstorm. Refer to a qualifi ed service
centre for all necessary repairs.
TV INSTALLATION AND SETUP
Instructions for assembling the stand
1. Install the stand into the glass base using 4 bolts (A) and 4 washers.
2. Place the stand with base carefully on the TV and tighten fi rmly using 4 bolts (B).
Positioning
•
Place the unit within the room so that the display is not exposed to direct
sunlight.
•
Complete darkness or refl ections on the screen can cause eye fatigue. Soft
indirect light is recommended for comfortable viewing.
•
Leave enough space between the device and wall to allow suffi
cient air
circulation.
•
Stay away from excessively warm areas to prevent damaging the case of the
device or the premature ageing of components.
•
Do not cover ventilation holes.
Antenna and power connection
1. Connect the antenna cable to the antenna connector on the back side of
the TV.
2. Plug the power cord into the electric socket.
3. Switch the TV on.
Press the On/Off switch on the TV. The indicator will turn green. When the
TV is in standby mode (red indicator), the TV can be turned on by pressing
a button on the remote controller.
Bolt B
Stand
Glass panel
Base
Bolt A