31
EN
WARNING
If you will not use the device for a longer period of time, remove the batteries. Do not leave
empty batteries in the device. Dispose of empty batteries in an environmentally safe manner.
Keep the batteries out of reach of children. The batteries are small objects, which a child might
swallow. If swallowed, consult a physician immediately. Do not disassemble, incinerate or attempt
to recharge the batteries. Do not mix new and used batteries together.
Step 3 – Filling the container of the dispenser
1.
Open the container cover and carefully remove the plug of the container.
2. Fill the container with the required liquid soap or disinfectant.
3. Open the battery compartment and move the dispensing switch to “Lo”
position (minimum amount).
4. 10 seconds time delay enables you to close the battery compartment
cover. (During this time delay, the dispensing is deactivated and the LED
indicator is lit in the dispenser sensor window.)
5. Put your hand under the dispensing nozzle. The touch-free dispenser
registers the presence of your hand and dispenses one dose of the liquid
soap.
After the fi rst use or after several days of inactivity, it is necessary
to activate the dispenser several times to fi ll the pump of the
dispenser with soap.
6. To change the amount of the dispensed liquid, open carefully the
battery compartment (without the hand coming between the dispenser
sensor and the nozzle), move the dispensing switch to “Med” (medium
amount) or “Hi” (large amount) and close the cover.
Cleaning function
To change the type of the liquid in the dispenser you can use the rinse
function. To activate the rinsing cycle, press the rinse button inside the
battery compartment. The device starts dispensing for 30 seconds. Repeat
the cycle until the container is empty. To rinse the device thoroughly, you
can add some water into the container and repeat the rinse.
Control
Dispensing switch
You can set the amount of dispensed soap using “Off ”, “Lo”, “Mid” or
“Hi”. We recommend that you set the switch to OFF position when you
replace batteries or clean the device with wet cloth.
Liquid level
The indicator of the liquid level shows the amount of liquid in the
container. When the level is low, it is necessary to add liquid to the
container.
Battery strength LED indicator
When it becomes necessary to replace weak batteries, the LED
indicator located in the sensor window will fl ash for 10 seconds during
dispensing of the liquid. To change batteries, follow the instructions in
the section “Battery installation”.
