55
EN
Inserting/removing an attachment
1. Select a suitable attachment (see also “Accessories” in the chapter
“Description of the appliance”).
2. Insert the attachment into the holder. Make sure that the attachment
is properly set into the shaft.
3. Set the safety key on the shaft. Make sure that the safety key is
correctly locked in place.
4. Turn the safety key to the left to lock the attachment in place.
5. If you want to remove the attachment, fi rst release the safety key by
turning it to the right.
6. Remove the safety key.
7.
Pull out the attachment.
Operating the appliance
1. Place the appliance on a fl at non-slip surface.
2. Plug the appliance in a properly installed electrical outlet.
3. Place a container for the grated foods under the opening of the attachment holder.
4. Press the push button switch to switch the appliance on. Before you
start inserting any food, press the button once or twice fi rst and check
if the attachment rotates correctly, meaning that it is fi tted well.
5. Then hold the push button and load foods which you want to process
into the hopper.
Attention:
Do not press hard on the foods, it could overload the motor
and burn it out, and the warranty might be voided and a warranty claim
denied.
