GB
33
33
33
The surfaces so marked become hot during use.
OPERATING INSTRUCTIONS
Before first use
•
Clean the appliance using dry cotton cloth prior to first use. Clean the hot
plates and the drip trays carefully, see the section “Cleaning and maintenance”
below. Do not use abrasive powders or abrasive cleaners.
•
Do not forget to return the drip tray in its place.
•
Unwind the power cable fully.
Note:
When you first start heating up, you may experience slight odor or smoke. This is normal for most
appliances with heating elements and does not present a threat to safety of your appliance. For this
reason, we recommend that plates are “burned” without food prior to first use, until the odour or smoke
is reduced. Keep the grill closed when burning off.
Food preparation
Warning:
•
Turn off the grill not only with the thermostat controller, but
always disconnect the power cord from the socket after each
use.
•
Do not use the appliance for defrosting or cooking of frozen foods. All foods must be completely defrosted
before processing by this appliance.
•
The plates and the metal surfaces of the appliance become very hot during operation. To avoid burns, use
heat-resistant gloves and touch only the handles and parts designed to be touched.
•
Do not use metal utensils, which could scratch and damage the non-stick surface of the plates.
Notes:
•
You can use the grill in 3 positions.
1)
Baking
2)
Grilling
3)
BBQ.
•
Reaching the working temperature takes about 3 to 5 minutes, the cooking time is
shown in the table at the beginning of this manual.
•
These times are only approximate. cooking time depends on the type and thickness of
the food.
•
The foods should be thoroughly cooked before eating. If you are not sure, better
lengthen the cooking time somewhat.
The position for baking and grilling
•
Baking:
You can decide if the upper plate will bake the food directly (contact grill) or if you leave a space
between the food and the upper plate and will just heat the food from the top – position (
1
).
•
Grilling:
You can leave the upper unused plate in the 90° position – position (
2
).
1. Place the excess grease tray to the drip groove. The tilt of the grill can be easily changed using adjustable
feet located at the bottom of the grill for better grease removal.
2. Place the grill on a level and dry surface and plug the power cable in the electrical outlet. The grill turns on
and the red indicator
POWER
comes on.
3. Using the thermostat control, set the required temperature an let the grill to warm up. Green light
READY
indicates that the plates are heating up. Once the plate is heated to the set temperature, the indicator
goes off.
4.
Opening the grill:
• Check, if the grill is heated to the required temperature (indicator light
READY
is off).
• Use the handle to open the lid with the upper plate (slider to adjust the
height of the grill on the right side of the upper plate must be in the “OPEN”
position).
Hot surface!
