English
English
9
3 – Installing the adapter panel to the wall board
Mount the adapter panel to the wall arm so that the adapter flange is placed on the wall board rails. Tighten
the M6 bolt on the wall board rails. Tighten the bolt firmly, but not too much.
4 – Cable fixing, tilt angle adjustment and tightening
You can insert the wiring through the cable hole on the wall arm of the bracket. After pulling the cables
through the hole, fit the enclosed cable organizer.
Loosen the screws on the wall arm plate to adjust the tilt angle of the TV as shown below. Loosen and tighten
the screws using a Phillips screwdriver and wrench. After adjusting the desired angle, tighten the screws firmly
again, but not with excessive force.
