GB
23
CARE AND MAINTENANCE
Emptying the water tank
The appliance has an automatic water evaporation system. The circulation of
condensed water cools the evaporator. This not only increases the effi
ciency of
cooling, but also saves energy.
When the water container is full the display shows message “FL” accompanied
by acoustic alarm. The compressor stops working automatically. In this case it is
necessary to empty the water. Proceed as follows:
1. Disconnect the appliance from power and remove the exhaust hose
assembly.
2. Place the air conditioner in a suitable place.
3. Remove the drain plug and drain the water from the appliance. You can lean
back the appliance slightly when draining it.
4. Carefully replace the drain plug.
5. Put back the exhaust hose and switch on the air conditioner.
Maintenance
Attention:
Turn off the appliance and disconnect it from power before cleaning and maintenance to prevent
injury by electric shock!
Cleaning the external surface
1. Unplug the power supply from the outlet.
2. Wipe it with a fi ne cloth. Do not use benzine, solvent or other chemicals for cleaning. These substances
could damage the surface of the device and deform plastic components.
3. Protect the appliance from water getting in.
Cleaning the fi lter
When the fi lter is gradually clogged with dust, the effi
ciency of air conditioning is reduced. If the fi lter becomes
clogged and the air conditioning effi
ciency decreases, it is necessary to clean the fi lter. We recommend to
clean the fi lter every 14 days. If the air is polluted it is necessary to clean it
more often.
Cleaning the top fi lter
:
1. Grasp the outer grill of the EVA fi lter
B
, press the lock and remove the
grill. Then unscrew the four screws holding the fi lter in the appliance
A
.
2. Put the EVA fi lter in a solution of neutral detergent and warm water
(about 40°C) and after washing it let it dry in the shade.
3. Replace the clean fi lter back. Turn on the air conditioner and operate it
as usual.
Cleaning the bottom fi lter:
1. Grasp the grill of the CON fi lter and remove it carefully
C
.
2. Put the CON fi lter in a solution of neutral detergent and warm water
(about 40°C) and after washing it let it dry in the shade.
Notes:
•
To clean the fi lter do not use overly hot water (ideal temperature is about 40°C) and aggressive cleaning
agents (alcohol, gasoline, paint thinners).
•
To avoid deformation of the fi lter protect it from heat and let it dry by itself.
•
Do not operate the appliance without inserted fi lter.
Seasonal maintenance
If you are not using the appliance for longer time do the following seasonal maintenance:
1. Remove the drain plug and drain the water from the appliance.
2. Let the unit run two hours in air fl ow mode (low speed) until the inside dries out completely.
A
C
B
MK 123_manual_cz_sk_en_hr.indb 23
18.2.2016 10:13:05
