ECG MS 002 B, Operating Manual

EN

24 

25

QUiCK sETUP

Step  1:  By  sliding  remove  the  battery  compartment  cover  in  the  back  of  the  device  and  insert  two  AA 

batteries. Carefully o/- polarity. Put on the battery compartment cover back. Now the device is ready 

to operate.

Step 2: The device begins to search wireless outdoor temperature sensor´s signal within first 3 minutes before 

DCF signal searching. If the device did not find any DCF signal in day, set the clock manually.

DEViCE LoCATiNG oR HANGiNG

To install the device on a table, set the holder on the device´s back; to install it on a wall, set the holder on the 

device´s rear. The longer and thinner holder´s side should be set on its rear or upper face.

Humidity level can significantly change according to the device´s location. Therefore install it in such a way 

as to work under appropriate conditions.

This thin side upwards

This thin side 

backwards

DCF siGNAL RECEPTioN AND iNDiCATioN

After turn on the device begins to receive DCF signal.   icon flashes.

DCF signal reception 

(  icon flashes)

Sufficient reception 

(  icon lights)

Poor reception 

(  icon disappears)

If the clock does not receive any DCF signal it begins to reach it later.

If DCF signal failure occurs the device selects the same frequency during next reception.

Automatic and manual reception

The clock begins to receive a signal every day at 01:00, 02:00, and 03:00. If no DCF time signal is received at 

03:00 reception is run also at 04:00. If this attempt fails new reception is run at 05:00. If no signal is received 

automatic information reception begins at 01:00 next day again.

Manual reception: By holding 

WAVE

 / 

V

 button, manual reception is run. To stop DCF signal reception, hold 

WAVE

 / 

V

 button for 2 seconds.

While receiving RCC 

sET

, 

ALM sET

, 

UP

, 

DoWN

, 

ALM oN-oFF

 buttons are not available and no temperature 

and humidity measurement is active. Temperature and humidity values settle down and stay precise after 

approx. 30 minutes since turning on.

sET UP DiARY, 12/24 H TiME iNDiCATioN

1.  Hold 

sET / ALM sET

 button for 2 seconds, time figures change into “2008 YR” and flash. To set year, press 

v

 / 

V

 button.

2.  Then press 

sET / ALM sET

 button again; month figures flash. To set month, press 

v

 / 

V

 button.

3.  After next pressing 

sET / ALM sET

 button, date figures flash. To set day, press 

v

 / 

V

 button.