EN
45
Manual signal reception:
Simply press and hold /
WAVE
. The device beeps briefly and starts manual
reception. Press and hold /
WAVE
to stop DCF reception.
When your weather station receives radio time signal, the display darkens. When the radio time signal is
received, the display returns to the previously set brightness level.
During radio time signal reception, the buttons of the device do not work and no temperature measurements
are carried out. The display shows the original temperature. Current, accurate temperature returns to display
after about 30 minutes.
SETTING THE CLOCK
1.
Hold the
SET
button for 2 seconds, the numbers on the clock start flashing. Using / set hour.
2.
Press again
SET
, the minute numbers start flashing. Using / set minutes.
3.
Press
SET
once again. The display shows flashing :05. Using / set the snooze interval in the
5–60 minutes range.
4.
Then press
SET
once again. The display shows 00. Using / select the time zone.
“00” = GMT +1 hour (i.e. Czech Republic)
“01” = GMT +2 hours (i.e. Finland)
“-01” = GMT 00 (i.e. Great Britain)
5.
Press
SET
to return to regular mode. When you will not press any button within about 10 seconds the
device will return to regular mode automatically.
6.
The clock is set in 24 hours format.
SETTING ALARM
(The default alarm clock setting is 6:00)
1.
Press and hold the
AL
button. The hours and the symbol AL start flashing. Using / set the desired
wake up time.
2.
Press
AL
again, the minute numbers start flashing. Using / set minutes.
3.
When you press
AL
again, you will save the alarm setting and return to regular time display. When you
will not press any button within about 10 seconds the device will return to regular mode automatically.
ALARM CLOCK TURN ON AND OFF
You will switch the alarm clock on or off by pressing
AL
.
When the alarm is on, symbol
AL
appears above the
time display.
SNOOZE
When the set alarm time is reached the alarm clock starts ringing and the
AL
symbol is flashing.
1.
Press snooze once
SNOOZE
to switch the alarm off temporarily, symbol
AL
continues flashing. If you did
not set another snooze time interval, the alarm will ring again 5 minutes later.
2.
If you want to switch the alarm clock off, press during ringing any button but snooze.
Alarm duration: 2 minutes
DISPLAY BRIGHTNESS SETUP
Press
SNOOZE/DIMMER
to set the display brightness high or low.
USING THE WEATHER FORECAST
The weather station uses four weather symbols:
Summary of Contents for MS 007
Page 2: ......
