GB
6
7
6. One press of the "DOWN" button decreases the value by 1 step; after
holding down the button for 2 seconds it decreases by 8 steps / seconds.
7. The phases of the moon change according to the selected date during
setting.
8. If no button is used for 8 seconds, the system automatically exits the
setting. The settings already made are saved.
Setting alarm
1. Press and hold the "ALARM" button for 2 seconds to open the alarm
setting.
2. The display flashes at a frequency of 1 Hz during setting.
3. Setting the alarm clock: hours
minutes
end.
4. One press of the "UP" button increases the value by 1 step; after holding
down the button for 2 seconds it increases by 8 steps / seconds.
5. One press of the "DOWN" button decreases the value by 1 step; after
holding down the button for 2 seconds, it decreases by 8 steps / seconds.
6. Press the "ALARM" button to confirm the setting and move to the next
item.
7. If no button is used for 8 seconds, the system automatically exits the
setting.
8. Press the "ALARM" button to turn the alarm on and off.
9. The BUZZER alarm sounds for 2 minutes as follows:
•
0 – 10 s: one beep per second
•
10 – 20 s: two beeps per second
•
20 – 30 s: four beeps per second
•
after 30 s: beeps continuously
10. You can press the "SNZ" button to start the snooze mode when alarm
sounds, when the alarm sounds again after 5 minutes, you can leave the
mode with any other button.
RCC reception function
Start RCC time reception
•
The device automatically starts receiving RCC time information 3
minutes after power on or reset.
•
Hold down the "DOWN" button for 2 seconds to forcibly start RCC
reception.
