GB
6
Time settings
1. In clock display mode, hold down the "TIME" button for 2 seconds to
open the setting mode.
2. Hold down the "UP" / "DOWN" buttons to set the item.
3. Press the "TIME" button to confirm the setting.
4. Repeat steps 2 and 3 to set the time.
5. The time setting mode ends automatically if no button is pressed for 30
seconds.
Setting alarm
1. Use the "ALARM" button to switch the mode to the alarm display, and
then hold down the "ALARM" button for 2 seconds to enter the setting
mode.
2. Hold down the "UP" / "DOWN" buttons to set the item.
3. Press the "ALARM" button to confirm the setting.
4. Repeat steps 2 and 3 to set the alarm time.
5. The alarm setting mode ends automatically if no button is pressed for
30 seconds.
6. The alarm is on after setting it.
VF reception function
•
After inserting the batteries, the temperature / humidity check is
performed and after 3 minutes, the RF reception mode starts.
•
In normal display mode, hold down the “CH” button for 2 seconds to
clear the channel information.
•
If no valid signal with the corresponding ID is received on the current
channel for 35 minutes, the temperature of the current channel displays
“-. -“.
•
When a valid signal is received, the normal temperature display
continues.
Alarm clock function
The alarm beeps for 2 minutes in the following order.
•
The first 0-10 seconds beeps once per second.
•
Next 10-20 seconds beeps twice per second.
•
Next 20-30 seconds beeps four times per second.
•
Next 30 seconds beeps continually.
