GB
7
•
If the setting is not changed for 8 seconds, the data is saved and the
setting ends.
•
Press the "ALARM" button to turn on / off the alarm,
•
Alarm sound for 2 minutes, alarm format:
•
0-10 s: one beep/second
•
10-20 s: two beeps/second
•
20-30 s: four beeps/second
•
30 s later: continuous beeping
•
When the alarm sounds, press the "SNZ" button, the alarm will move
ahead by 5 minutes, press another button to end the alarm.
Temperature monitoring settings
•
Hold down the "UP" button for 2 seconds to enter the ALERT setting
mode.
•
Setting order: upper limit, lower limit, ON / OFF, exit
•
When setting limits, press the “CH” button to assign different channels.
•
The default value of the upper limit is + 70 ° C and the lower limit is -50
° C.
•
During setting, the value flashes at a frequency of 1 Hz.
•
Press the "MODE" button to confirm the setting and move to the next
item.
•
Pressing the "UP" button changes the setting one step up, holding for
more than 2 seconds changes the setting by 8 steps every second.
•
Pressing the "DOWN" button changes the setting one step up, holding
for more than 2 seconds changes the setting by 8 steps every second.
•
If the setting is not changed for 8 seconds, the setting is terminated.
Start & reset
•
During start-up or reset, the LCD display and illumination light up fully
for 3 s, a beep sounds and the device goes into standby; the temperature
and humidity test takes place, after 3 minutes the RF signal from the
sensors is received, the auto RCC signal and the device terminates the
connection for 7 minutes.
•
Default alarm: 0:00
•
Default weather icon: partly cloudy
•
Default temperature: °C
•
Default clock format: 24H
