7
Assembly
1. Unscrew the bolt and take off the upper bracket.
2. Mount the armrest: Unscrew the nut and put
four bores in order on the upper armrest. Insert
the bolt and screw it with a nut.
3. Mount the connecting rod: Pull out the pinchcock
and pin bearing, then drill through a bore on the
connecting rod with a pin bearing. Insert the
pinchcock in the pin bearing, and screw the other
side on the connecting rod with a nut.
4. Mount the rocker: Plug the rocker inside of
gimbal from the armrest panel, so that the
rocker bore aims at the bore on the gimbal.
Then, insert the pinchcock.
5. Mount the chute: Unscrew the bolt on the chute,
place it on the chute seat, align the fixed block
with a bore, and screw the fixed block with a bolt.
