6
SETUP
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty
Use
1
Oval-head bolts
Curved washers
Handle knobs
2
2
2
Install the handle.
2
No parts required
-
Install the recoil starter handle.
3
Discharge chute assembly
Screws
Washers
Locknuts
1
2
2
2
Install the discharge chute
assembly.
4
Bottle of engine oil
1
Fill the engine with oil.
5
No parts required
-
Adjust the control cable.
1.
Installing the Handle
Parts needed for this procedure:
Oval-head bolts
Curved washers
Handle knobs
2
2
2
Procedure
1.
Position the ends of the upper handle on
the inside of the lower handle and align
the holes.
2.
Insert the oval-head bolts into the aligned
holes, with the bolt heads on the outside
of the handle (Figure 1).
3.
Install the curved washers and the handle
knobs on the bolt on the inside of the
handle (Figure 1) and tighten the knobs
securely.
Important: Ensure that the cable is
routed to the outside of the handle.
2.
Installing the Recoil
Starter Handle
Parts needed for this procedure:
(none)
Procedure
Install the recoil starter handle in the rope
guide as shown in Figure 2.
Figure 1
Figure 2
