ECHO Robotics RP-1200 Quick Start Manual Download

Page: 2 / 4

RP-1200 Quick Start Guide

P/N YB-071-00016-0A

REVISED 11/05/2019

ENGLISH

Power Switch

The power switch is under the cover on the back right-
hand side of the robot.

OFF

Move the power switch to the OFF position for extended
idle time or winter storage.

The Smartbox

Lift the STOP button up to access the Smartbox.

Use the Smartbox to configure the robot.

Starting

To start the robot, press and hold

for five

seconds, then release it. The start-up procedure takes
approximately two minutes.

If the robot does not start, return it to the charging
station and completely charge the battery.

Stopping

Press the STOP button to stop the robot.

OFF

RP-1200

SEC

MIN

PUSH

WAIT

Summary of Contents for RP-1200

Page 1: ...Keep animals away from the robot Water cleaning with high pressure jet systems can cause damage The robot is protected by an access code Read the technical manual before using the robot Press the STOP...

Page 2: ...tended idle time or winter storage The Smartbox Lift the STOP button up to access the Smartbox Use the Smartbox to configure the robot Starting To start the robot press and hold for five seconds then...

Page 3: ...on after charge instructs the robot to remain in the charging station after it is fully charged Set Operating Parameters Press on the Smartbox to access the SETTINGS menu Use the SETTINGS menu to set...

Page 4: ...le application Service Inspection Inspect the robot at least once a week move the power switch to the OFF position check the condition of the blades verify that the cutting heads rotate freely remove...