Set Up:
1.
Position the amplifier (A) in a convenient and well-ventilated
area that is easily accessible and near to the TV or other audio
source.
2.
Starting from the amplifier, run the loop cable (C) round the
room. It may be fixed to a skirting board, picture rail or tucked
under the carpet (use clips provided D). The cable can be tacked
up and over door frames if necessary. Make sure you leave
enough wire to reach the amplifier.
3.
If using a loop pad (optional), place the pad in a suitable
position on the chair to be used and connect the lead from the
pad to the cable terminals (12) on the back of the amplifier. Lay
the connecting lead carefully, so as not to cause an obstruction or
tripping hazard, leading to injury.
4.
Once a complete loop of the room has been formed, cut away
any surplus wire making sure to cut away the insulation from the
wire ends. Clip each end of the wire into loop cable connector (12)
on the amplifier. Press the button on the loop cable connector
(12) and a hole will appear, insert the cable (C) and release the
button to lock the cable in place.
6
