12
Drive Shaft Assembly
Level 1.
Parts required:
POWER BLENDX
TM
8 oz. (P/N 91014) or
Lithium Based Grease.
WARNING
Hedge Clipper blades are very sharp. Touching them may lead to
severe personal injury. Avoid touching blades whenever possible,
and always wear gloves to protect hands
1. Remove gear housing locating screw (A) and loosen clamping
screw (B). Remove the gear housing assembly from the drive shaft
housing.
2. Pull the drive shaft (C) from the housing, wipe clean and re-coat
with a thin coating [1/2 oz. (15 ml)] of grease.
3. Slide the flexible shaft back in the drive housing being careful not
to get dirt on the flex shaft.
A
B
C
A
Gear Housing Assembly
Level 1
Parts required:
POWER BLENDX
TM
14 oz. cartridge P/N 91015 or
Lithium Based Grease
1. Clean dirt from grease fitting (A).
2. Carefully pump grease in fitting.
DO NOT
force grease.
Too much pressure will force grease past seals and cause damage.
Apply 1-2 pumps of grease every 15-25 hours of operation.
