S
haft
h
edge
C
lipper
a
ttaChment
O
peratOr
'
S
m
anual
13
1. Move stop switch to stop position.
2. Disconnect spark plug wire.
3. Slide blades to allow file clearance using slots (B) on bottom of
blade. Do not pry against cutting edges.
4. File each edge carefully. Follow the original shape of the blade.
IMPORTANT
If a power grinder is used
DO NOT
allow blade to over heat.
5. Lubricate blades (see “Lubrication instructions”).
IMPORTANT
Blades should only be removed and reinstalled by an Authorized
ECHO Servicing Dealer, otherwise premature wear or internal
damage may occur.
C
D
A
B
4. Slide Gear Housing Assembly onto Drive Shaft. Be certain the
Flex Drive Shaft engages the hole in Driver Gear.
IMPORTANT
Flat edge of washers (D) must be against drive shaft.
5. Align locating hole in gear housing with locator hole in drive
shaft.
6. Install locating screw (A). Tighten clamping screw (B).
sharpenIng
blades
Level 2.
Parts required:
None
WARNING
Hedge Clipper blades are very sharp. Touching them may lead to
severe personal injury. Avoid touching blades whenever possible,
and always wear gloves to protect hands.
6mm (.25 in.)
Radius
B
45º
