S
haft
h
edge
C
lipper
a
ttaChment
O
peratOr
'
S
m
anual
9
fronT
loop
handle
removal
Parts Required:
None
NOTE
Front loop handles/loop handles with barrier bars are not recom
-
mended for use with Hedge Clipper attachment.
1. Remove front handle assembly, barrier bar (if installed), and
mounting hardware from PAS or SRM-SB power head.
2. Retain parts for future use.
NOTE
Lower bearing housing and head assembly must be in line with
the engine.
6. Select desired blade position by aligning one of the holes (F) in
lower shaft with locator pin position.
7. Rotate locator pin (A) 1/4 turn clockwise to engage lower shaft
hole. Insure locator pin is fully engaged by twisting lower drive
shaft. Locator pin should snap flush in coupler. Full engagement
will prevent further shaft rotation.
8. Secure lower shaft assembly to coupler by tightening clamping
knob (D).
D
C
A
