10
A
RESETTING
TINES
FOR
DEEP
CULTIVATION
Tools Required: 10 mm Wrench
The tines are factory assembled with blade ends offset for standard
cultivation. For deep cultivation, the left tine (viewed from the operator's
position) must be repositioned on the hub aligning the left and right tine
blade ends directly across from each other.
1.
Remove three (3) bolts (A) mounting left tine to hub. The bolts will
be mounted in hole labeled (1).
2.
Rotate tine counter clockwise and position hole labeled (2) over
hub mounting holes. The tine blade ends should be aligned
directly opposite each other.
3.
Install and tighten bolts.