Connecting to the Audio Interface
headphone output jack, with a corresponding volume knob, which monitors analog
outputs 1 and 2.
AudioFire8 has six analog line inputs (3 – 8) and eight analog line outputs on the
rear panel. These analog inputs (3 – 8) operate with an input impedance of
10Kohms. The input and output connections can be used with balanced or
unbalanced cables via the ¼” connectors. By default, the inputs and outputs are set
to receive or send a +4dBu signal.
You can switch b4dBu and –10dBV for each individual input and output
via the console software (see section below). There are also two channel inserts on
the rear panel where you can connect a serial effects device (compressor, EQ, etc.)
for the universal inputs (1 – 2). The channel inserts are wired: tip = send, ring =
return, and sleeve = ground.
16
Connecting to the Audio Interface
