10 English
TROUBLESHOOTING
MAINTENANCE
While holding the string head body, rotate the string head
base counter-clockwise to wind the line on the spool until
approximately 6 in. of line is showing on each side.
Push down on the string head face while pulling on line(s)
to manually advance the line and to check for proper as-
sembly of the string head.
Storing the Trimmer
Remove the battery pack from the string trimmer before
storing.
Clean all foreign material from the trimmer.
Store it in a place that is inaccessible to children.
Keep away from corrosive agents such as garden chemi-
cals and de-icing salts.
Problem
Possible Cause
Solution
Line will not advance
Line is welded to itself.
Not enough line on spool.
Line is worn too short.
Line is tangled on spool.
Spool in string head is not
installed correctly.
Lubricate with silicone spray.
Install more line. Refer to
Line Replacement
earlier in
this manual.
Pull line while pushing down on string head face.
Remove line from spool and rewind. Refer to
Line
Replacement
earlier in this manual.
If the string head has been disassembled for any reason,
make sure the side of the spool stamped with the letter
L is facing out when reassembled.
Grass wraps around boom
housing and string head
Cutting tall grass at ground
level.
Cut tall grass from the top down to prevent wrapping.
Motor fails to start when switch
trigger is depressed
Battery is not secure.
Battery is not charged.
To secure the battery pack, make sure the battery is fully
seated and the latch on the tool is snapped into place.
Charge the battery pack according to the instructions
included with your model.
Motor stops while switch trig-
ger is depressed.
Motor is overloaded.
Release switch trigger, wait several seconds, then
depress trigger again. Motor should restart. If it doesn’t,
remove battery pack, reinstall battery pack, then try again.
Summary of Contents for CDST-58V
Page 16: ...12 English NOTES...
Page 26: ...12 Fran ais NOTES...
