14
4.
Recoil Starter
Lay the unit on a flat clear area. Firmly grasp throttle grip with
left hand and fully depress throttle trigger to wide open position.
Gently pull recoil starter handle/rope (D) until engine fires or 2 to 3
engine engagements.
5.
Choke
After engine fires or 2 to 3 engine engagements, move choke lever
to “Run” position. Hold throttle trigger fully depressed and pull
starter handle/rope until engine starts and runs. Release throttle
trigger and allow unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in “Run” position after 5 engine
engagements, repeat instructions.
6.
After engine warm up, gradually depress throttle trigger to increase
engine RPM to operating speed.
STARTING
WARM
ENGINE
WARNING
DANGER
The cutting attachment should not rotate at idle. If attachment
rotates, readjust carburetor according to "Carburetor Adjustment"
instructions in this manual or see your ECHO Dealer, otherwise
serious personal injury may result.
1.
Stop Switch
Move stop switch button (A) away from the STOP position.
2.
Recoil Starter
Lay the unit on a flat clear area and gently pull the recoil starter
handle (D) until engine fires.
NOTE
If engine does not start after 5 engine engagements, use Cold Start
Procedure.
D
D
A
Summary of Contents for GT-2000EZR
Page 2: ......
