Echo GT_225 - 11-09, Operator'S Manual

G

rass

 T

rimmer

O

peraTOr

'

s

 m

anual

15

maIntenance

Intervals

m

aIntenance

Your ECHO trimmer is designed to provide many hours of trouble free service. Regular scheduled maintenance will help 

your trimmer achieve that goal. If you are unsure or are not equipped with the necessary tools, you may want to take 

your unit to an ECHO Service Dealer for maintenance.  To help you decide whether you want to DO-IT-YOURSELF 

or have the ECHO Dealer do it, each maintenance task has been graded. If the task is not listed see your Echo dealer for 

repairs.

skIll

level

Level

1

 =  Easy to do. Common tools may be required.

Level

2

 =  Moderate difficulty. Some specialized tools may be required.

ECHO offers 

REPOWER

TM

 Maintenance Kits and Parts to make your maintenance job easier.

 WARNING

Moving parts can amputate fingers or cause severe injuries.  Keep hands, clothing and loose objects away from all 

openings.  Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete 

stop before removing obstructions, clearing debris, or servicing unit. Allow unit to cool before performing service. 

Wear gloves to protect hands from sharp edges and hot surfaces.

COMPONENT/SYSTEM

MAINTENANCE

PROCEDURE

SKILL

LEVEL

REQ'D

DAILY OR 

BEFORE

USE

EVERY

REFUEL

3 MONTHS 

OR 90 

HOURS

YEARLY 600 

HOURS

Air Filter

Inspect/Clean

1

I / C *

R*

Choke Shutter

Inspect/Clean

1

I / C

Fuel Filter

Inspect/Replace

1

I *

I / R *

Fuel Cap Gasket

Inspect/Replace

1

I  *

R *

Fuel System

Inspect/Replace

1

I  (3)

I (3)

Spark Plug

Inspect/Clean/Replace

1

I / C / R *

Cooling System

Inspect/Clean

2

I / C

Muffler Spark Arrestor

Inspect/Clean/Replace

2

I / C / R *

Cylinder Exhaust Port

Inspect/Clean/Decarbon

2

I / C

Drive Shaft 

Inspect/Grease

2

I (1)

Gear Housing

Grease

2

I (2)

Recoil Starter Rope

Inspect/Clean

1

I / C * 

Screws/Nuts/Bolts

Inspect/Tighten/Replace

1

I  *

* All recommendations to replace are based on the finding of damage or wear during inspection.

(2) Apply  POWER BLENDX

TM

 every 50 hours of use.

(3) Low  evaporative fuel tanks DO NOT require regular maintenance to maintain emission integrity.

MAINTENANCE PROCEDURE LETTER CODES:  I = INSPECT,  R = REPLACE,  C = CLEAN
IMPORTANT NOTE 

- Time intervals shown are maximum. Actual use and your experience will determine the 

frequency of required maintenance.

MAINTENANCE PROCEDURE NOTES:

(1) Apply  POWER BLENDX

TM

 every 25 hours of use.