16
Before you start
2. Place throttle cable into adjustment fixture and install wire
end into large carburettor throttle swivel hole.
3. The throttle lever free play should be approximately 4-6 mm.
4. Turn the adjustment nut in or out as required to obtain proper
free play 4-6 mm.
5. Make sure that the throttle lever operates smoothly without
binding.
6. Check throttle for freedom of movement and that wide open
throttle / low idle extremes are adjusted properly.
7. Tighten
locknut.
8. Connect 2 ignition leads from throttle cable tubing to 2 igni-
tion leads on engine.
9. Secure ignition leads against engine with clips.
10. Install air cleaner cover.
1. Throttle cable
2. Adjustment fixture
3. Throttle swivel hole
4. Adjustment nut
5. Locknut
1. Ignition leads
1. Ignition leads
2. Clip
3. Clip
CAUTION
Wiring runs must not interfere with throttle operation.
