15
Engine operation
Engine operation
Starting the engine
Starting a cold engine
(Connect the spark plug cap if the product has been in storage for
a long period of time)
The starting procedure depends on whether the engine is cold or
warm. A cold engine is started as follows.
1.
Remove the blade cover and check the cutter blades. If an-
ything is wrong, replace it with a new one.
2.
Placing the product on level ground, check to ensure that the
blades does not come into contact with the surface of the
ground or any other impediment using a beam or other such
implement.
3.
Check that there are no fuel leaks.
4.
Move the ignition switch away from the Stop position.
5. Move the choke lever to the "Cold Start" position.
6.
Alternately press and release the purge bulb until the fuel is
sucked up into it.
DANGER
The blades will move if the throttle latch is depressed. Before using the device, make sure that there are no people
or impediments in the vicinity.
Should a person or other object contact the blades, an accident or injury could be caused.
WARNING
When starting the engine, observe the precautions described from Page 4 in the section "For safe use of your prod-
uct" to ensure that you operate the product correctly.
If the cutter blade moves even though the throttle trigger is in the idle speed position when the engine is started,
adjust the carburettor before using the product.
Cutter blade will start moving as engine attains clutch engagement speed.
Failure to observe the precautions could cause an accident or injury, or even lead to a fatality.
NOTE
Pull out the starter grip gently at first, and then more rapidly. Do not pull the starter rope out to more than 2/3 of its length.
Do not let go of the starter grip as it returns.
1. Ignition switch
2. Throttle trigger
3. Throttle trigger lockout
1. Choke lever
2. Purge bulb
3. Cold Start
4. Run
Summary of Contents for HCR-150
