3E
WAND CLIP
The wand can be attached to the
pump handle using the wand clip.
SPRAYER COMPONENTS & USE INFORMATION, Continued
Pump Handle
Positioned For Use
(right hand shown)
Figure 1
Figure 2
Line up holes
Figure 3
Slide bolt through holes
Figure 5
Right Hand
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft
(A). To install the pump handle place the handle (C) over the shaft
(A) aligning the pump handle holes and shaft holes. Slide the bolts
(B) through the aligned holes as shown in figure 1 thru 4. Tighten
nuts (D) to bolts. There are holes in the pump handle to allow for
either right (fig.5) or left (fig.6) hand mounting.
Figure 6
Left Hand
Figure 4
Tighten nut to bolt
Threaded Bolt
Nylon Lock Nut
C. Pump Handle
A. Pump Shaft
B. Bolts
D. Nuts
