Echo MS-53BPE, Use And Care Manual

WARNING

WARNING: Handling the brass parts of this product will expose you to lead, a chemical 
known to the State of California to cause birth defects and other reproductive harm. 
Wash hands after handling.

CAUTION

1E

WARNING: Improper use or failure to follow instructions can result in explosive 
failure causing serious eye or other injury. For safe use of this product you must read 
and follow all instructions. Do not leave a pressurized sprayer in the hot sun. Heat can cause 
pressure build-up resulting in possible explosion. Do not store or leave solution in tank after 
use. Always wear goggles, gloves, long sleeve shirt, long pants and full foot protection when 
spraying. Never use any tool to remove pump if there is pressure in the pressure chamber. 
Never pressurize sprayer by any means other than the original pump. Do not attempt to 
modify this sprayer. Replace parts only with manufacturer’s original parts. Never spray 
flammable,  caustic,  acidic,  chlorine,  bleach  or  other  corrosive  solutions  or 
heat, pressure, or gas producing chemicals. Always read and follow chemical 
manufacturer’s instructions before use with this sprayer as some chemicals may 
be hazardous when used with this sprayer.

•  PRE-USE CHECK: Before each use check tightness of hose nut to be sure hose is 
  securely attached to the shut-off assembly. Insure hose is securely attached to the 
  pump outlet by tightening hose nut. Insure that all nozzle and wand connections 
  are tight. Insure the three bolts (underside of base) used to attach the piston 
  cylinder are tight.

•  Do Not exceed a tank solution temperature of 120º F/ 49º C.

NOTE: The tank and hose may have residual water in it due to quality testing 
performed on the sprayer.

SK 1158-1