HANDLE AND CONTROL SYSTEM
PB-251
24
4-2 Reassembling handle and throttle control (continued)
3. Install throttle trigger (F) onto throttle trigger post
(G) as shown.
4. Hook the ball end (H) of throttle cable in the end
of throttle rod. Then insert the other throttle rod end
(I) into the hole of throttle trigger. Make sure throttle
rod is placed in throttle rod guide (J).
5. Install throttle cover (K).
6. Install handle (L).
7. Hook flat coupler lead (M) from cylinder to the rib
(N).
8. Hook round coupler lead (O) from cylinder to the
ribs (N, P, Q). Route it behind ignition switch.
9. Hook two leads (R, S) from ignition switch to the
ribs (P, Q). Route it behind the ignition switch.
10. Connect flat coupler lead (M) from cylinder to
terminal of ignition switch as shown. Hook lead to
the rib (N) as shown.
11. Connect flat coupler lead (R) from ignition switch
to terminal of ignition switch as shown. Hook lead
to the rib (Q) as shown.
12. Connect round coupler leads (S) and (O). Put
leads into the grooves (T) as shown.
NOTE:
Keep each lead in correct position so that
handle lid can be installed correctly.
13. Install handle lid, muffler cover and air cleaner
cover.
(M)
(R)
(O)
(S)
(M)
(N)
(L)
(P)
(Q)
(R)
(S)
(G)
(J)
(F)
(H)
(I)
(K)
(O)
(N)
(Q)
(T)
Summary of Contents for PB-251
Page 1: ...Ord No 403 16...
