14
O
PERATION
• Recoil starter: Use short pulls - only 1/2-2/3 of rope length for
starting. Do not allow the rope to snap back in. Always hold the unit
firmly.
• (PB-750H): Rotate spring loaded throttle arm downward to a comfort-
able operating position.
STARTING
COLD
ENGINE
PB-750H
1.
Throttle Lever
Move throttle lever (A) to IDLE DETENT position.
PB-750T
1.
Throttle Lever/Stop Switch
Move throttle lever (A) forward to idle position. Slide stop switch
(B) forward to run position.
PB-750H, PB-750T
2.
Choke
Move choke (C) up to "Cold Start" position (
).
3.
Primer
Pump primer bulb (D) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
4.
Recoil Starter
Pull recoil starter handle (E) until engine fires (5 or 6 pulls maxi-
mum).
5.
Choke
Move choke (C) down to run position (
), and if necessary,
restart engine.
NOTE
If engine does not start after 5 pulls, move choke to "Cold Start"
position, and repeat steps 4 & 5.
NOTE
Allow engine to warm up before use.
A
PB-750H
PB-750T
B
A
D
C
E
