MAINTENANCE
PB-760LN
34
X7531125905
© 10/19 ECHO Incorporated
2.
Pull the fuel filter from the tank.
3.
Do not remove the wire coil clamp to remove the fuel filter. Pinch the
fuel filter with the fingers on one hand and the fuel line with the other
hand. Pull and twist slightly to separate.
4.
Install the new filter with the reverse action.
Note: Federal EPA regulations require all model year 2012 and later
gasoline powered engines produced for sale in the United
States to be equipped with a special low permeation fuel
supply hose between the carburetor and fuel tank. When
servicing model year 2012 and later equipment, only fuel
supply hoses certified by EPA can be used to replace the
original equipment supply hose. Fines up to $37,500 may be
enforced for using an un-certified replacement part.
Spark Plug
Level 2.
Use only NGK BPM-6Y spark plug (BPMR-6Y in Canada) otherwise
severe engine damage may occur.
1.
Remove spark plug and check
for fouling, worn and rounded
center electrode.
2.
Clean the plug or replace with a
new one. DO NOT sand blast to
clean. Remaining sand will
damage engine.
3.
Adjust spark plug gap by
bending outer electrode.
4.
Tighten spark plug to 150-170 kgf • cm (130-150 in • lbf).
Parts Required:
TUNE-UP KIT
0.65 mm (0.026 in.)
