12
O
PERATION
• Check unit for loose nuts, bolts, and screws daily.
• Recoil starter: Use short pulls - only 1/2-2/3 of rope length for
starting. Do not allow the rope to snap back in. Always hold the unit
firmly.
STARTING
COLD
ENGINE
1. Throttle Lever/Stop Switch
Slide stop switch (A) forward to run position.
2. Choke
Move choke (B) up to Cold Start position (
).
3. Primer
Pump primer bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
4. Recoil Starter
Pull recoil starter handle (D) until engine fires (5 pulls maximum).
5. Choke
Move choke (B) down to run position (
), and if necessary,
restart engine.
NOTE
If engine does not start after 5 pulls, move choke to "Cold Start"
position, and repeat steps 4 & 5.
NOTE
Allow engine to warm up before use.
D
B
C
A