© 06/2020 ECHO Incorporated X7152270100
3
QUICK START GUIDE / GUÍA DE INICIO RÁPIDO / GUIDE DE DÉMARRAGE
RAPIDE
PAS-225 / PAS-2620
Pro Attachment Series
™
Use The Correct Personal Protection
ALWAYS WEAR
NEVER WEAR
• Hearing Protection
• Loose Clothing
• Eye Protection
• Jewelry
• Heavy, Long Pants
• Short Pants, Short Sleeve Shirt
• Boots
• Sandals
• Gloves
• Barefoot
• Long Sleeve Shirt
• Long Hair Below Shoulders
Equipment Safety
Before Each Use Inspect:
• For damaged parts.
• Loose or missing fasteners.
• Cutting attachments for damage (cracked, chipped, etc.).
• Cutting attachment is securely fastened.
• Cutting shield is correct for cutting attachment and secured according
to this manual.
•
Manufacturer recommended flexible non-metallic line is installed in the
trimmer head.
• Guards are installed correctly.
• For fuel leaks from any point of the fuel system (tank to carburetor).
Use only ECHO attachments. Serious injury can result from the use
of a non-approved attachment combination. ECHO, INC. will not be
responsible for the failure of cutting devices, attachments or accessories
which have not been tested and approved by ECHO. Read and comply
with all safety instructions.
• Do not attempt to modify this product. Serious injury can result from
the use of any modified product.
• Check unit for loose or missing nuts, bolts, and screws. Tighten or
replace as needed.
• Inspect shield for damage and ensure that shield is properly installed,
and that the cut-off knife is securely in place. Replace if either is
damaged or missing.
•
Check that the cutting attachment is firmly attached and in safe
operating condition.
•
Manufacturer recommended flexible non-metallic line is installed in the
trimmer head.
• Assure that throttle trigger, throttle trigger lockout, and stop switch all
work properly.
• Check that handle and harness (if included) are installed and adjusted
for safe, comfortable operation. See Assembly Section for proper
adjustment.
•
Moving parts can amputate fingers or cause severe injuries. Keep
hands, clothing and loose objects away from all openings.
• ALWAYS stop engine, disconnect spark plug, and make sure all
moving parts have come to a complete stop before assembling unit,
removing obstructions, clearing debris, or servicing unit.
• Do not connect spark plug lead to spark plug until unit is ready for use.
• DO NOT start or operate unit unless all guards and protective covers
are properly assembled to unit.
• NEVER reach into any opening while the engine is running. Moving
parts can not be visible through openings.
• Position wiring safely to prevent snagging, separation of connectors,
or breakage during operation. Gather excess wire, and secure with
wiring clamp if provided on equipment, or tuck behind the air filter
area. Do not place wiring directly against hot engine components.
•
Check wiring and connectors for nicks, cuts, exposed wire, or other
damage, and repair or replace as needed. Exposed wire or connectors
can cause shocks, sparks, and risk of fire or explosion, resulting in
serious injury.
• Check wire terminals for secure connections.
• Periodically check fuel system (fuel lines, vent, grommet, fuel tank,
and fuel cap) for leaks especially if the unit is dropped. If damage or
leaks are found, do not use unit, otherwise serious personal injury
or property damage can occur. Have unit repaired by an authorized
servicing dealer before using.
Fuel Handling
•
Fuel is VERY flammable. Use extreme care when mixing, storing or
handling, or serious personal injury will result.
•
Mix and pour fuel outdoors where there are no sparks and flames.
• Slowly remove the fuel cap only after stopping the engine.
•
Do not smoke while fueling or mixing fuel.
• Wipe spilled fuel from the unit.
• Move at least 3 m (10 ft) away from the fueling source and site before
starting engine.
Work Area
• Review the area to be cleared. Remove potential hazards such as
rocks, broken glass, nails, wire, or metal objects, which can be thrown.
• Clear the area of children, bystanders and pets.
• At a minimum, keep all children, bystanders and pets outside a 15 m
(50 ft) radius.
• Outside the 15 m (50 ft) zone, there is still a risk of injury from thrown
objects.
• Bystanders should be encouraged to wear eye protection.
• Avoid blowing debris towards people, pets, open windows, or vehicles
when using unit.
• If you are approached, stop the engine and cutting attachment.
• When a bladed unit is used, there is the added risk of injury to
bystanders being struck with the moving blade in the event of a blade
thrust or other unexpected reaction of the blade.
INFORMACIÓN IMPORTANTE Y SÍMBOLOS DE
SEGURIDAD DEL MANUAL
A lo largo de este manual y en el producto mismo, encontrará alertas de
seguridad y mensajes informativos de gran utilidad precedidos por símbolos o
palabras clave. A continuación se enumera una explicación de dichos símbolos
y palabras clave y su significado.
El símbolo de alerta de seguridad acompañado por la palabra
"PELIGRO" destaca un acto o condición que LLEVARÁ a que se
produzcan lesiones personales graves o la uerte si no se evita.
El símbolo de alerta de seguridad acompañado por la palabra
"ADVERTENCIA" destaca un acto o condición que PUEDE llevar a que
se produzcan lesiones personales graves o la muerte si no se evita.
El mensaje adjunto proporciona información necesaria para proteger la
unidad.
Nota: Este mensaje adjunto proporciona sugerencias para el uso, cuidado y
mantenimiento de la unidad.
