26
Cleaning silencer
1. Silencer.
2. Two bolts.
3. Silencer cover.
4. Hexagonal wrench.
Clean deposits from silencer and tighten two bolts.
Angle transmission
1. Plug (bolt).
2. Angle transmission.
Remove plug from angle transmission.
Add grease, if necessary, using low pressure pump.
Reinstall plug.
Lubricating drive shaft (flexible shaft)
1. Flexible tube.
2. Flexible shaft.
Disconnect the flexible tube from the engine.
Pull flexible shaft from the flexible tube, wipe clean and recoat with a thin coating 10 to 20
g, of lithium base grease.
Slide the flexible shaft back in the flexible tube.
Do not get dirt on the flexible shaft.
Install the flexible shaft into the flexible tube, then reconnect the flexible shaft assembly to
the engine.
For maximum shaft life, the flexible shaft should be reversed "end-for-end" during
reinstallation.
NOTE
Use good quality lithium multi grease.
Do not overfill housing.
NOTE
Use good quality lithium multi grease.
