STARTER SYSTEM
CSG-7410ES
EC741S
10
2-2 Assembling starter assembly
WARNING DANGER
Use of eye protection and safety gloves are
strongly recommended while working on re
-
wind spring.
1. If rewind spring (N) is removed from rope reel (M),
wind the spring (N) inside rope reel (M) as shown.
NOTE:
Apply small amount of lithium based
grease to surface (m2) of rope reel before winding
the spring.
2. Apply lithium based grease on around shaft (a1)
of starter case (A) if dry.
3. Carefully install rope reel (M) on starter case (A)
as shown.
4. Pull out starter rope (K) inside starter case (A).
Rotate rope reel (M) clockwise several turns with
starter rope hooked at notch (m1) as shown. Hold
rope reel (M) to prevent spring from unwinding and
pull out starter grip to take the rope slack.
5. Pull starter grip several times to check rewind
spring tension. If starter is not rewinding fully, in-
crease spring tension by rotating rope reel (N) one
more turn clockwise following above step 4.
NOTE:
Lightly hold rope reel (M) by hand to pre-
vent rewind spring from unwinding when pulling
starter grip.
6. Pull out starter rope (K) all the way, and check
that rope reel can be rotated an additional half or
more turn clockwise as shown, to prevent rewind
spring from breaking.
7. If rope reel can not be turned clockwise, reduce
tension by rotating rope reel counterclockwise one
turn with starter rope hooked at notch (m1).
M
N
m2
A
M
a1
m1
A
M
K
lithium
