STARTER SYSTEM
CSG-7410ES
EC741S
12
Q
G
d
E
B
A
F
d
A
B
C
D
B
2-3 Replacing oilseal
1. Remove cover (G) from starter assembly. (Refer
to “2-1 Disassembling starter assembly”)
2. Pry oilseal (Q) from cover (G).
3. Install new oilseal (Q).
2-4 Replacing starter pawl
1. Remove starter assembly from unit.
2. Loosen bolt (A) with 10mm socket wrench and
remove pawl (B), spacer (C) spacer (C) and tor-
sion spring (D). Replace damaged or worn parts.
NOTE:
When it is hard to loosen bolt, install piston
stopper X644-000020 (E) in spark plug hole to stop
crankshaft rotation and remove bolt easily.
3. Install torsion spring, spacer, pawl (B) and bolt (A).
To avoid torsion spring from pinching, install these
parts without setting the end (d) of torsion spring
on pawl (B).
4. Using fine wire (F) or appropriate tool, place the
end (d) of torsion spring on pawl (B), by hooking
and passing under pawl as shown. Remove fine
wire (F) or tool.
5. Make sure pawl (B) can move smoothly. If it
does not move smoothly, check parts for correct
installation.
