3
Installation Instructions
(Refer to Fig. 1 – Fig. 4)
:
1. Plug the EchoSL
TM
mains power adapter (B) into a standard
electrical power socket, then plug the power lead into the DC 12V
socket on the back of the EchoSL. (10).
2. Press the power button (9) ON and the power ON light (8) will
give a constant red light.
3. Starting from the amplifier, run the loop wire (C) around the edge
of the room. The wire can be tacked up and over door frames if
necessary. The wire can be tucked under the carpet or clipped to
the skirting board. Make sure you leave enough wire to reach the
amplifier.
4. Once a complete loop of the room has been formed, cut away
any surplus wire making sure to cut away the insulation from the
wire ends. Clip each end of the wire into terminals on the back of
the EchoSL. (11).
5. If you are using a loop pad (Optional), clip the end of the lead
into the terminals (11). Never run the lead across the floor unless
fully under the carpet. Remember that loose wires are a tripping
hazard.
6. If your TV has audio output sockets connect the Phono/Phono
lead to these sockets and plug the other end of the lead into the
EchoSL line input socket (13). If your TV has no audio output
sockets but has a spare SCART socket, plug the scart into the
TV and connect the Phono/Phono lead. Then connect the Phono/
Phono end into the Line Input socket of the EchoSL. (13). please
note using SCART connection sometimes results in picking up
sound signal that does not correspond with the program being
watched.
